Cub Cadet Z-Force S 48 Manual De Instrucciones página 13

Indicator Panel Features
Battery Indicator
Illuminates and the battery voltage is displayed briefly when the
ignition switch it turned to the "ON" position.
Illuminates to indicate the battery voltage has dropped below
11.5 (+0.5/-1.0) volts. The battery voltage is a Iso displayed on
the hour meter. If this indicator and display come on during
operation, check the battery and charging system for possible
causes and/or contact your Cub Cadet dealer.
Oil Pressure Indicator (If Engine So Equipped)
This warning lamp indicates low engine oil pressure. If the
indicator comes on while the engine is running, stop the engine
immediately and check for possible causes. Do not run the
engine while this indicator is illuminated. Contact your Cub
Cadet dealer to have the tractor and engine inspected.
NOTE:The oil pressure indicator may illuminate when the
ignition switch is in the ON position, but should turn offwhen
the engine is started.
PTO Engaged Indicator
This indicator illuminates when the PTO switch is pulled upward
in the "ENGAGED" position and the ignition switch is turned
to the "START" position. Check this indicator if the engine will
not crank with the ignition switch in the "START" position. If
necessary, move the PTO switch to the "DISENGAGED" position.
Parking Brake Engaged Indicator
This indicator illuminates when the parking brake is in the
DISENGAGED position and the ignition switch is turned to the
"START" position. Check this indicator if the engine will not crank
with the ignition switch in the "START" position. If necessary,
move the parking brake to the ENGAGED position.
This indicator also illuminates when the ignition switch is turned
to the "START" position and the RH and/or LH drive control levers
are in a position other than the fully out in neutral position. Move
the control levers fully outward.
ThrottleControl
The throttle control is located on the RH console
to the right of the operator's seat. When set in a
given position, a uniform engine speed will be
maintained.
Push the throttle control handle forward to increase
the engine speed. The tractor is designed to operate
with the throttle control in the fast position (full _lh
throttle) when the tractor is being driven and the
mower deck is engaged.
Pull the throttle control handle rearward to decrease the engine
speed.
ChokeControl
The choke knob controls the position of the
engine choke and is located on the RH console.
Pull the knob out to choke the engine; push the
knob in to open the choke.
ParkingBrakeEngagementLever
The parking brake engagement lever is located on the left
of the seat box frame, and is used to engage the parking
brake.
Pull the lever reward to stop the tractor or slow it down.
Pull the lever fully rearward and to the right; then into the
short "J" slot to engage the brake.
Pull the lever up out of the "J" slot and to the left; then
completely forward to disengage the parking brake.
DrivePedal
The drive pedal is located on the right side
of the tractor, along the running board. Press
the drive pedal forward to cause the tractor to
travel forward. Ground speed is also controlled
with the drive pedal. The further forward the
pedal is pivoted, the faster the tractor will travel. The pedal will
return to its original position when it's not pressed.
ReversePedal
The reverse pedal is located on the right
side of the tractor along the running board.
Ground speed is also controlled with the
reverse pedal. The further downward the
pedal is pivoted, the faster the tractor will
travel. The pedal will return to its original
position when it's not pressed.
|
SECTION 4
-- CONTROLS AND FEATURES
13