Cub Cadet Z-Force S 48 Manual De Instrucciones página 28

Changingthe SpindleAssembly
1. Remove the deck from beneath the tractor, (refer to Deck
Removal on page 25).
2. Remove the hex washer screws securing the belt covers
to the deck and remove the belt from the spindle pulleys.
Refer to Fig. 7-10.
1. Remove the drive belt. (See Replacing the Belt)
2. Remove the blade. (See Mower Blade Care).
3. Use a 3/4"wrench to hold the hex nut on top of the spindle
assembly when loosening the hex nut securing the blade.
A block of wood may be placed between the deck housing
and the cutting edge of the blade to help in breaking loose
the hex nut securing the blade. See Fig. 7-12.
Hex
Washer-===-_'
Screw
S
Pulley
_He× Screw
Spacer
)indle Assembly
Figure 7-12
NOTE:Take note of the order that the parts composing the
assembly are placed.
4. Using a wrench or socket ratchet remove four hex washer
screws. Remove the spindle assembly. See Fig. 7-12.
5. Reverse the process to install the spindle assembly.
Changingthe Transmission DriveBelt
Several components must be removed and special tools used in
order to change the tractor's transmission drive belt. See your
Cub Cadet dealer to have the transmission drive belt replaced.
SECTION 7--
SERVICE