mundoclima MUPO-H8 Manual De Instalación Y Usuario página 43

Control Panel
-
+
4. or button
a. Each time the + or - button is pressed, the setting temperature will increase or
decrease by 1℃(1℉). The setting temperature ranges from 16℃ (60℉)～32℃(90℉).
b. By pressing both the + and - button at the same time(≥3s), the display will toggle
between Celsius and Fahrenheit.
5. / button
The mode indicator light illuminates under the different mode.
Note: HEAT mode is not available for cool only units.
6. button
/
7. / button
Press the "
a.
b. Press + or - button to select the desired time.
c. After setting time 5 seconds without other operation, the timing function will be
initiated automatically. If you press the timer button, there are no operation within 5
seconds or setting time is 0, the timing function will be cancelled automatically.
d. When the timing function is initiated, the unit displays the remaining time by press
the "timer" button once and cancel the timing function by press it again.
Note With the unit on, press this button to set off timer. :
With the unit off, press this button to set on timer.
8. button Press this button, the
/
Press this button, you can select the running mode as follows:
auto cool
Press this button to enter sleep mode, which the unit will exit after
8 hours of continuous operation and restore to the previous status.
Note: The SLEEP function can not be activated in fan and dry mode.
" button, the timer indicator light illuminates.
/
dry fan heat
indicator light will illuminate.
43