Troubleshooting - mundoclima MUPO-H8 Manual De Instalación Y Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Troubleshooting

To save
the cost
of a service call, please try the suggestions below to see if you can
solve your problem without outside help.
Causes
The power switch is released.
Power supply failure.
The fuse is burnt.
It doesn't reach the setting time for
starting up.
Unit Doesn't Start When Pressing ON/OFF Button
Causes
It is not four minutes after switch off.
Room temperature is lower than the
setting temperature under cooling mode
or higher than setting temperature under
heating mode.
The Wind Blowing Out, But The Cooling / Heating Effect Is Bad
Causes
Mistakes in temperature setting.
The air filter is blocked by dust.
The air inlet or outlet of machine is
blocked.
Turn the air conditioner on in very
hot room.
Cooling capacity is insufficient.
The doors or windows are open.
Causes
The ground is not level or not flat enough.
Air Condition Will Not Operate
Noise
or vibration
54
Solutions
Switch on the power.
Wait for the recovery of power supply.
Replace the fuse by professional .
Wait or eliminate the original setting.
Solutions
Wait four minutes.
Reset the setting temperature.
Solutions
Set a proper temperature, setting
temperature should be lower than
ambient temperature.
Clean the air filter.
Remove the obstruction.
Allow additional time to remove stored
heat from walls ,ceiling, floor and furniture.
Reconfirm the required cooling / heating.
capacity with your dealer.
Close the doors and windows.
Solutions
Place the unit on a flat, level ground
if possible.

Publicidad

Tabla de contenido
loading

Tabla de contenido