Installing The Intrusion Switch - Dell EMC PowerEdge R230 El Manual Del Propietario

Figure 19. Removing the intrusion switch
1 intrusion switch
3 intrusion switch cable
5 cable routing clip (2)
Next steps
1 Install the intrusion switch.
2 Follow the procedure listed in
Related links

Installing the intrusion switch

Installing the intrusion switch
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple
repairs as authorized in your product documentation, or as directed by the online or telephone service and support team.
Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
1 Ensure that you follow the
2 Follow the procedure listed in
Steps
1 Slide the intrusion switch into the intrusion switch slot.
2 Route the intrusion switch cable through the cable routing clips.
3 Connect the intrusion switch cable to the connector on the system board.
Después de manipular el interior del sistema
Instrucciones de seguridad.
Antes de trabajar en el interior de su
2 intrusion switch slot
4 intrusion switch connector on the system board
equipo.
Instalación y extracción de los componentes del sistema 63