Before Startup; Unloading Tips - Windsor RRB 360 T Manual De Instrucciones

Before Startup

Open/ close device hood
DANGER
Danger of crushing while closing the ma-
chine cover. Hence, lower the machine
cover slowly.
Prior to commissioning, maintenance or
adjustment tasks, the appliance cover must
be opened.
 Grab the front of the appliance cover
and fold it back together with the seat.
 A retaining band keeps the appliance
cover in the rear position.

Unloading tips

Danger
Risk of injury, risk of damage!
Observe the weight of the appliance when
you load it!
Do not use a forklift truck to unload the ma-
chine as this may damage it.
Note
Press the emergency-stop button to imme-
diately deactivate all functions and turn the
key switch to the "0" position.
Weight (without batteries)
* If upgrade kits are installed, the weight is
respectively higher.
 Use a suitable ramp or a crane to load
the appliance!
 If the machine is delivered on a pallet,
you must create an unloading ramp us-
ing the boards provided.
To unload the machine, proceed as follows:
 Cut plastic packing belt and remove foil.
 Remove the elastic tape fasteners at
the stop points.
 Four indicated floor boards of the pallet
are fastened with screws. Unscrew
these boards.
 Place the boards on the edge of the pal-
let. Place the boards in such a way that
they lie in front of the four wheels of the
machine. Fasten the boards with
screws.
 Slide the four support beams included
in the packaging under the ramp.
 Remove the wooden blocks used for ar-
resting the wheels and slide them under
the ramp.
8
Push the sweeper off the pallet (appli-
ance without built-in battery)
DANGER
Risk of injury! Before releasing the im-
–
mobilizing brake, the machine must be
secured to prevent it rolling away. After
releasing the emergency brake, the ap-
pliance will roll until a speed of 4.5 km/
h is reached. After that, the electronics
will brake the appliance.
It is prohibited to release the emergen-
–
cy brake on an incline without using the
stopper.
 Release parking brake.
 Remove the brake level from the wheel
and put it in its position.
The immobilizing brake is thus deacti-
451 lbs * vated; the machine can now be moved.
(205 kg *)
 Slide the machine over the prepared
ramp from the pallet.
Drive the sweeper off the pallet (appli-
ance with built-in battery)
 Connect the battery, refer to Chapter
"Connecting and installing the battery".
 Release emergency-stop button by
turning.
 Set main switch to "1".
 Press the drive direction switch and
slowly move the machine down from
the ramp.
 Set main switch back to "0".
Safety notes regarding the batteries
Please observe the following warning notes
when handling batteries:
Observe the directions on the
battery, in the instructions for
use and in the vehicle operat-
ing instructions!
Wear an eye shield!
Keep away children from acid
and batteries!
Risk of explosion!
Fire, sparks, open light, and
smoking not allowed!
Batteries
7
-
US
Danger of caustic material!
First aid!
Warning note!
Disposal!
Do not throw the battery in the
trash bin!
Danger
Risk of explosion! Do not put tools or similar
on the battery, i.e. on the terminal poles
and cell connectors.
Danger
Risk of injury! Ensure that wounds never
come into contact with lead. Always clean
your hands after having worked with batter-
ies.
Danger
Risk of fire and explosion!
Smoking and naked flames are strictly
–
prohibited.
Rooms where batteries are charged
–
must have good ventilation because
highly explosive gas is emitted during
charging.
Batteries must not be stored outside.
–
Danger
Danger of caustic material!
Rinse thoroughly with lots of clear water
–
if acid gets into the eye or comes in con-
tact with the skin.
Then consult a doctor immediately.
–
Wash off the acid If it comes in contact
–
with the clothes.
Installing and connecting the batteries
 Open the device hood.
 Insert batteries into the battery mount.
 Adjust the rubber buffers to hold the
batteries properly.
Warning
Pay attention to correct poles.
Note
The connection lines are not included in the
delivery scope.
1.
2.
4.
3.
5.