NIPRO Diagnostics TRUE2go Manual Del Propietário página 25

7. With Test Strip still in Meter, touch edge of
Sample tip to blood drop and allow blood
to be drawn into Strip. Remove Test Strip
Sample Tip from sample drop immediately
after dashes appear across the Meter Display.
Holding the Test Strip Sample Tip to the blood
Caution!
sample too long after the Meter begins testing may
cause inaccurate results.
Note:
If Meter does not begin testing soon after touching blood
drop to Sample Tip, discard Strip. Repeat test with
new Strip and new blood drop. If problem persists, see
Troubleshooting.
8. Dashes appear across Display to show Meter
is testing. Remove Strip from drop.
9. After the test is finished, result is displayed.
Record result in log book.
10. Hold Meter with Strip pointing down. Press
Strip Release Button to discard Strip in the
appropriate container. Meter turns off.
Result is stored in Memory.
Note:
Removing Strip before result displays
cancels the test. An error message
appears and result is not stored in
Memory. Retest with a new Strip
and do not remove before result is
displayed.
23