Installation; Installation Site (Qualified Specialist); Assembly Site; Installation Position - BADU JET Perla Traduccion De Las Instrucciones

Installation

5 Installation
5.1

Installation site (Qualified specialist)

5.1.1

Assembly site

Select the assembly site and prepare it in accordance with

Fig. 4. If the unit is being used in an above ground pool, the
telescopic support foot must be used, for attachment
instructions See "Fig. 5" on page 20.
5.1.2

Installation position

 The unit is normally installed on the narrow side of the pool
with a recommended minimum pool length of 4 m.
 From a pool width of 4 m, installation on the longer side is
also possible.
 For round and oval pools made from smooth sheet steel or
plastic, a minimum radius of 2 m is required.
 For round and oval pools made from made from stone or
concrete, a flat surface with a minimum width of 480 mm is
required.
 The water depth at the position of installation should be
between 1.2 m and 1.5 m. Thus the massage hose can be
used appropriately and optimally.
5.1.3

Checklist

 Check the unit contains all parts listed in the packing list.
5.1.4

Fastening the unit to the ground

 Set the unit on the edge of the pool and mark the mounting
holes.
5.1.5

Drilling the mounting holes

 Lift the unit and drill the Ø10 mm holes on the markings. See
"Fig. 4" on page 19
5.1.6

Inserting the brass dowels

 Insert brass dowels (25) and screw on the metal vibration
buffers (26). See "Fig. 6" and "Fig. 7" on page 21.
 Ensure that the bolts anchor the buffers securely into the
base, so that the unit sits securely.
18 EN 09|2018