Grohe SENSE GUARD 22 503 Manual De Instrucciones página 7

• GROHE Sense Guard must only be used
in good order and condition, as intended,
and with safety and hazard awareness by
adhering to the operating instructions.
• Malfunctions must be immediately
remedied.
• Use only original spare parts and
accessories. The use of other parts will
void the warranty and the cTÜVus, cUPC
and NSF marking, and could cause injury.
Software and internet connection:
• In order to ensure operation as a fully-
functioning device, both the smartphone
used and the GROHE Sense Guard must
be connected to the internet and the
device must be successfully installed with
the GROHE ONDUS app beforehand.
Otherwise, the device is not configured
and no warning messages can be given.
GROHE takes all necessary measures to
ensure safe and correct use. In the event
of a malicious attack by third parties,
GROHE advises to install the latest
firmware and/or disconnect the device
from the power supply grid until you
receive further information from GROHE.
Intended use
GROHE Sense Guard is suitable for use in cold potable water
up to a maximum water temperature of 104 °F (40 °C).
GROHE Sense Guard is only permitted to be installed in
potable water installations for detached houses and flats that
have separate water supply lines.
The GROHE Sense Guard meets the requirements of IAPMO
IGC 349-2017.
Compliance statement (part 15.19)
This device complies with part 15 of the FCC Rules and with
Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device
must accept any interference received, including interference
that may cause undesired operation.
Warning (part 15.21)
Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to
operate the equipment.
RF Exposure (OET Bulletin 65)
To comply with FCC RF exposure requirements for mobile
transmitting devices, this transmitter should only be used or
installed at locations where there is at least 7 7/8'' (20cm)
separation distance between the antenna and all persons.
Information to the User (Part 15.105 (b))
Note: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation.
If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and
receiver.
- Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for
help.
GROHE ONDUS app and connection to the internet
GROHE Sense Guard connected to the internet via WLAN can
be integrated and configured in the GROHE ONDUS app. This
app can be used to provide warnings and alarms in the form of
push notifications.
A WLAN router with internet access
(2.4 GHz, IEEE 802.11b/g/n) is required.
Only WLAN channels 1 – 11 can be used.
Installation of the app:
Apple: Android:
If the app or the device firmware requires updating, the
smartphone must be located in the immediate vicinity of the
GROHE Sense Guard. In this way, possible interruptions in
function can be controlled and rectified.
Installation
Prior to installation, go through the individual installation
guide and read the instructions in full!
Guide for the individual
planning of the installation:
guard-
installation.
grohe.com
Installation, see page 2 or 3
Prior to installation, the water supply must be shut off.
In the case that other pressure effective devices are installed
at the premises it is required that the GROHE Sense Guard is
installed downstream of those devices.
6
Complete operating instructions
and other technical information:
www.grohe.com/
tpi/sense-guard