Toto NEOREST SE Manual De Instrucciones página 14

Precautions for first-time bathing
The temperature of the hot water into the function module must be at least 140°F (60°C) and 158°
F (70°C) or less.
● If the temperature of the hot water supply is low, it won't be possible to fill the tub with water at the
temperature set using the controller. The function module mixes the hot and cold water, releasing it
from the outlet to fill the tub with warm water. The temperature of the water coming from the outlet is
always lower than that of the hot water supply.
Please keep about 13-3/8" (34 cm) of water in the tub while bathing.
● If the water level is low then there may be some functions that don't work, like the shoulder warmer.
The tub has foot rests for your feet for maintaining
a proper bathing position in the tub.
● Please avoid sliding into the tub by keeping your
hands on the rim of the tub or your feet on the foot
rests.
ӿ Please do not grasp the pillows. They could
come out and injury or drowning could result.
For a pleasant bathing experience, please change the water
in the tub daily.
We also recommend draining the water out of the tub soon
after bathing.
When draining the tub, run the water draining function to
remove the residual water from the pipes. ► See page 33.
● If the water is frequently left in the tub until the next day or if the
tub is drained but the residual water is not removed then residue
could build up in the pipes. This could cause an offensive odor.
14
Pillow
Foot rest
Nice and clean
Rim of tub
Pillow