Toto NEOREST SE Manual De Instrucciones página 9

Button status
Buttons displaying a ■ or a □ indicate their operating mode or the fact that they are on or off.
ON (■)
When the lower four but-
tons are on, the back-
lighting looks orange.
Turning off the display
If a specific amount of time passes without any controller operations after all operations have stopped, then the
screen will go out by itself. Pressing a button (with no display) will turn the screen on and make operation possible.
Turn the on/off button to off. Or
after around 30 minutes, if the
equipment has not been running or
if no buttons have been pressed.
The screen is lit and the control will work.
Other
There may be times when the display flashes or when there are streaks of color or brightness in the backlighting,
but these are not things that will affect the operation of the controller. Please be aware of that in advance. There
may be times when the controller will stop working in close proximity (around 50 cm) to an incandescent light or in
direct sunlight. Please adjust the angle of the controller stand or darken the surroundings before continuing.
9
If any button is pressed.
(Any button at all)
There are three states. The left edge
(■) indicates the selected mode. The
display changes each time a button is
pressed.
■□□→□■□→□□■
OFF (□)
The backlighting looks blue.
The backlighting will go dark after about 10
seconds, when nothing is running.
Or after around 10 minutes, if the
equipment has not been running or
if no buttons have been pressed.
The screen will be dark.