Shower
The water won't turn off.
Are the hot and cold water knobs turned completely off?
Water dripping from the shower can be from residual water flowing inside the shower head. It is not
broken.
The hot/cold water doesn't work. There isn't enough flow.
Are the water main and shut off valves turned on far enough?
Are the knobs turned on far enough?
Has the water been shut off or could it be frozen?
The water's always cold.
Does the water heater produce enough hot water?
→ Please check the temperature and operating settings on the water heater.
Is the hot water knob turned on?
The water's always hot.
Is the cold water knob turned on?
Filling the bathtub
There isn't enough water flowing out.
Is there debris trapped in the filters in the hot or cold water connections in the function module?
→ Please clean them. ► See page 39.
Is there enough hot water from the water heater?
→ Please check the temperature and operating settings on the water heater.
→ Please set the hot water supply temperature to 140-158°F (60-70°C)
Are the water main and shut-off valves turned on?
Is there water pressure? ► See page 13.
The water is lukewarm.
Is the temperature setting on the controller low? → Please increase the setting. ► See page 17.
Is it adding cold water?
Is there enough hot water coming from the water heater?
→ Please check the temperature and operating settings on the water heater.
→ Please set the hot water supply temperature to 140-158°F (60-70°C)
Is there debris trapped in the filters in the hot water connections in the function module?
→ Please clean them. ► See page 39.
Is there water pressure? ► See page 13.
The water is too hot.
Is the Fill-Tub temperature setting too high? → Please lower the setting. ► See page 17.
Is it adding hot water? → Hot water is added at 118°F (48°C)
Is there debris trapped in the filters in the cold water connections in the function module?
→ Please clean them. ► See page 39.
Is there water pressure? ► See page 13.
44