Toto NEOREST SE Manual De Instrucciones página 22

Raising the bath temperature (Heating water)
This adds hot water to raise the temperature of the bath water.
Switch screens.
ӿ Turn this button off or check to see that it is

Please operate with the On/Off button set to on.

This won't work unless there is water in the tub. Put water in the tub. ► See page 17.
Turn the Higher button to on.

Please press for one second.
The water will flow after about 10 seconds (but at most 20 seconds).
Water that is 118°F/48°C will flow from the Fill-Tub outlet. Please be care-
ful of the high temperature.
When the bath water has reached the desired temperature, turn off the
Higher button.
The water flow will stop after about 10 seconds.
ӿ When the horizontal gauge (about 26 gallons or about 100 L) on the screen reaches the end, it will
stop automatically.
Press

This won't work if the Lower button or the Higher button is on.
22
.