Toto NEOREST SE Manual De Instrucciones página 39

Water drain plug (with filter)
When debris and other things block the filters in the water drain plugs, the following will happen, so
please keep them clean.

The volume of water flowing out will fall and it will take a long time to fill the bathtub.

The water will not flow out like a waterfall.

The temperature of the water will be unsatisfactory.
ӿ After hot water has been run into the bathtub from the fill-tub spout, the water remaining in the function
module will be very hot. To prevent scalds, please wait until after the equipment has cooled.
ӿ Since hot and cold water will come out of the water drain valve, please place a bucket or other container
below the function module to catch any water.
Turn off the hot and cold water shut-off valves connected to the connect-
ing port.
●The positioning of the shut-off valves will vary by site.
Hot water connection
Cold water connection
Set the
●Please operate with the On/Off button set to on.
Check to see that water is not flowing from the Fill-Tub outlet and then
set the On/Off button to off.
ӿ If the water continues to flow, set the On/Off button to off once again and then start at Step 1.
●Occasionally, the controller will display error code 572. This is a water shut-off notice. After resetting
the error (►See page 43), please set the On/Off button to off and proceed to Step 4.
Remove the water drain plugs.
●Please be aware that water in the function module will flow out when removing the water drain plugs.
●If you are unable to turn the water drain plugs and remove them manually, please insert a screwdriver or
similar tool into the hole in the water drain plug and turn it with the tool.
Cold water connection
Water drain plug
(with filter)
39
Function module (continued)
Close
Cold water valve
on the controller to on and wait for about 20 seconds.
Close
Hot water valve
Hot water connection
Water drain plug
(with filter)