Quantum Bus Supply Opt Switches And Leds; Status Leds - Lutron Quantum QP2-0P0CSE-120 Manual Del Usuario

Quantum Bus Supply OPT Switches and LEDs
TM
H/L H/L N N
ERR
EMG
BUS
ERR
EMG
BUS
STAT
V PWR
E1 E1 E1 E1
E2 E2 E2 E2
blue loop
green loop
10 Quantum Light Management Hub
TM
OPT Switch Functions
1
2
3
4
5
6
7
8

Status LEDs

LEDs on the Quantum Bus Supply indicate network status. The specific LEDs,
color and flashing method is detailed below.
ERR
LED
EMG
BUS
ERR
V PWR On
EMG
BUS
STAT
STAT
V PWR
BUS
ERR /
EMG
OFF
position position
H/L H/L N N
E2 E2 E1 E1 E2 E2 E1 E1
Addressing
Set address for
bus supply's loops
(2 loops per bus supply)
Green loop (right side)
Manual override levels
Blue loop (left side)
Manual Override levels
Manual Override
Normal Operation Problem Indicator
Off
Steady flash Off
On
Intermittent flash On
or Off
Off On
Steady flash
OPT Switches
OPT switches are used to
configure the Bus Supply.
The tables below describe
the options. To place an OPT
switch in the OFF position,
ON
slide the switch to the left;
away from the switch's
number. Default is ON (next to
the switch's number).
Bus Supply 1 Bus Supply 2
Addresses 1, 2 Addresses 3, 4
Lights stay at Lights go to
current level "high" level
Lights stay at Lights go to
current level "high" level
Manual override levels
will be used
Probable Cause
No Mains power
No Mains power or unit fault
Unit fault
Unit fault
Emergency contact closure is
active
Miswire detected on
corresponding bus
Bus Supply 3 Bus Supply 4
Addresses 5, 6 Addresses 7, 8
Lights go to Lights go to
"low" level Off
Lights go to Lights go to
"low" level Off
Lights will go to the level
specified by the system
R