Before Starting Generator; Add Engine Oil; Add Gasoline - Generac GP5000 Manual Del Propietário

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

3.6 — Before Starting Generator
Add engine oil and gasoline to the generator before oper-
ation. Proceed as follows:
3.6.1— Add Engine Oil
All oil should meet minimum American Petroleum Insti-
tute (API) Service Class SJ, SL or better. Use no special
additives. Select the oil's viscosity grade according to the
expected operating temperature. See Figure 3-7.
SAE 30 above 32° F (0° C)
10W-30 between 40° F and -10° F (4° C and -23°
C)
Synthetic 5W-30 for all temperature ranges
10W-30
Synthetic 5W-30
-20 -10 0
10 20
32
°F
-30
-20
-10
0
°C
Temperature Range of Expected Use
Figure 3-7. Engine Oil Requirements
*
Any attempt to crank or start the engine
before adding the recommended type and
quantity of engine oil can result in engine
damage.
Place generator on a level surface (not to exceed
1.
15° in any direction).
Clean area around oil fill plug/dipstick.
2.
Remove oil fill plug/dipstick.
3.
Wipe dipstick with a clean cloth.
4.
Install oil fill plug/dipstick and finger tighten.
5.
See Figure 3-8. Remove oil fill plug/dipstick and
6.
verify that the oil level is near the H(igh) mark.
NOTE: The hash mark closest to the fill plug is the
H(igh) mark.
Slowly add the recommended type of oil until the
7.
level is near the H(igh) mark on the dipstick. If nec-
essary, stop adding oil to check the engine oil level.
DO NOT OVER FILL.
NOTE: For oil capacity, see Subsection 6.2 — Engine
Specifications.
Install oil fill plug/dipstick and finger tighten.
8.
NOTE: Check engine oil level before each use.
Owner's Manual for Portable Generator
SAE 30
40
60
80
100
10
20
30
40
L (Low)
Figure 3-8. Oil Fill Plug/Dipstick
3.6.2— Add Gasoline
$
Never fill fuel tank indoors. Never fill fuel
tank when engine is running or hot. Do not
spill gasoline on a hot engine. Allow engine
to cool before filling fuel tank.
$
Do not overfill fuel tank. Always leave room
for fuel expansion. If fuel tank is overfilled,
fuel can overflow onto a hot engine causing
FIRE or EXPLOSION. Wipe up any spilled fuel
immediately.
$
Gasoline is highly FLAMMABLE and its
vapors are EXPLOSIVE. Never permit smok-
ing, open flames, sparks or heat in the vicin-
ity while handling gasoline.
Add only regular UNLEADED gasoline to fuel tank.
1.
Do not use gasoline with more than 10% added
ethanol. Do not use E85 gasoline. Do not mix oil
with gasoline.
Clean area around fuel fill cap before removal.
2.
Slowly add gasoline to fuel tank to avoid overfilling.
3.
See Figure 3-9.
NOTE: For fuel tank capacity, see Subsection 6.2 —
Engine Specifications.
Install fuel fill cap and finger tighten.
4.
Wipe up any spilled gasoline.
5.
Fuel Tank
Fuel
Figure 3-9. Fuel Tank
Operation
H (High)
DO NOT Fill
Above Lip
13

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Gp5500Gp6000eGp6500e

Tabla de contenido