Channel Level - Pioneer FS-W40 Manual De Instrucciones

> Before Start > Part Names
Wireless Speaker
This setting cannot be selected if audio is being output from the speakers of the TV.
■ Setup Mode
Setup Mode Select how to setup the audio output of the speakers.
"Easy (Default Value)": To use "Easy Setup" for a simplified
setup
"Standard": When you want to set the Distance and Channel
Level for each speaker individually
■ Easy Setup
You can easily set the distance and volume level for each of the speakers. To make more
detailed settings, set "Setup Mode" to "Standard", then set the distance and volume level for
each speaker individually.
■ Distance
This can only be selected when the "Setup Mode" is "Standard".
Front Left Specify the distance between each speaker and the listening
position. (Default Value is 3.00m (10.0ft))
Front Right Specify the distance between each speaker and the listening
position. (Default Value is 3.00m (10.0ft))
Surround Right Specify the distance between each speaker and the listening
position. (Default Value is 3.00m (10.0ft))
Surround Left Specify the distance between each speaker and the listening
position. (Default Value is 3.00m (10.0ft))
Subwoofer Specify the distance between each speaker and the listening
position. (Default Value is 3.00m (10.0ft))
0 Distance units can be switched by pressing MODE on the remote controller. When the
unit is set as meters, you can set between 0.03 m and 9.00 m in increments of 0.03 m.
When the unit is set as feet, you can set between 0.1 ft and 30.0 ft in increments of 0.1ft.
> Install > Setup > Playback
Supplementary information | Firmware Update | Others

■ Channel Level

This can only be selected when the "Setup Mode" is "Standard".
Front Left Select a value between "
increments). A test tone will be output each time you change the
value. Select the desired level. (Default Value is 0 dB)
Front Right Select a value between "
increments). A test tone will be output each time you change the
value. Select the desired level. (Default Value is 0 dB)
Surround Right Select a value between "
increments). A test tone will be output each time you change the
value. Select the desired level. (Default Value is 0 dB)
Surround Left Select a value between "
increments). A test tone will be output each time you change the
value. Select the desired level. (Default Value is 0 dB)
Subwoofer Select a value between "
increments). A test tone will be output each time you change the
value. Select the desired level. (Default Value is 0 dB)
■ Scan
Use this to rescan for speakers when wireless satellite speakers and wireless subwoofer
(sold separately) are added to the system. When performing this operation, first switch the
power of the sound system controller to standby, then connect the power cords of all the
speakers, then proceed.
12 dB" and " 12 dB" (in 1 dB
– +
12 dB" and " 12 dB" (in 1 dB
– +
12 dB" and " 12 dB" (in 1 dB
– +
12 dB" and " 12 dB" (in 1 dB
– +
15 dB" and " 12 dB" (in 1 dB
– +
E
N
15