Listening To The Fm Radio - Pioneer FS-W40 Manual De Instrucciones

> Before Start > Part Names

Listening to the FM Radio

a
c
d
e
> Install > Setup
Tuning into a Radio Station
Tuning Automatically
1. Press TUNER on the remote controller.
2. Press MODE (e) on the remote controller so that
"TunMode: Auto" appears on the display.
3. When you press the cursor
remote controller, automatic tuning starts, and searching
stops when a station is found. When tuned into a radio
station, the "TUNED" indicator on the display lights.
When tuned into a stereo FM station, the "FM STEREO"
indicator lights.
0 No sound is output while the "TUNED" indicator is off.
When FM broadcasts reception is poor: Radio waves
may be weak depending on the building structure and
environmental conditions. In that case, perform the
procedure as explained below in "Tuning Manually" to
manually select the desired station.
Tuning Manually
b
1. Press TUNER on the remote controller.
2. Press MODE (e) on the remote controller so that
"TunMode: Manual" appears on the display.
3. While pressing the cursor
controller, select the desired radio station.
0 The frequency changes by 1 step each time you press
the button. The frequency changes continuously if the
button is held down and stops when the button is
released. Tune by looking at the display.
To return to the auto tuning mode: Press MODE (e) on
the remote controller again so that "TunMode: Auto"
appears on the display. The unit tunes automatically into a
radio station.
> Playback
Supplementary information | Firmware Update | Others
Presetting a Radio Station
It allows you to register up to 40 of your favorite radio
stations. Registering radio stations in advance allows you to
tune into your radio station of choice directly.
/ buttons (a) on the
Registration Procedure
1. Tune into the radio station you want to register.
2. Press +Fav (d) on the remote controller so that the preset
number on the display flashes.
3. While the preset number is flashing (about 8 seconds),
repeatedly press the cursor  /
remote controller to select a number between 1 and 40.
4. Press +Fav (d) on the remote controller again to register
the station. When registered, the preset number stops
flashing.
Selecting a Preset Radio Station
1. Press TUNER on the remote controller.
2. Press the cursor  /
controller to select a preset number.
/ buttons (a) on the remote
Deleting a Preset Radio Station
1. Press TUNER on the remote controller.
2. Press the cursor  /
controller to select the preset number to delete.
3. After pressing +Fav (d) on the remote controller, press
CLEAR (c) while the preset number is flashing to delete
the preset number.
0 When deleted, the number on the display goes off.
E
N
buttons (a) on the
buttons (a) on the remote
buttons (a) on the remote
33