Display - Pioneer FS-W40 Manual De Instrucciones

> Before Start > Part Names

Display

1. Lights in the following conditions.
HDMI: HDMI signals are input and selected.
ARC: Audio signals from the ARC compatible TV are input and selected.
USB: When "USB" is selected with the input selector and the unit is connected by USB
and the USB device is selected. Flashes if the USB is not properly connected.
NET: When "NET" is selected with the input selector and the unit is connected to the
network. It will flash if the connection to the network is not correct.
DIGITAL: Digital signals are input and the digital input selector is selected.
2. Lights when operating the "NET" or "USB" input selector indicating remote controller
cursor operations are possible in screens showing list of tracks, for example.
3. Lights when operating the "NET" or "USB" input selector when tracks are played or
paused.
4. Lights according to the type of input digital audio signals and the listening mode.
5. Lights in the following conditions.
6
> Install > Setup
  
AAC
> Playback

Neo:6

RDS: Receiving RDS broadcasting.
AUTO: When tuning mode is auto.
TUNED: Receiving FM radio.
FM STEREO: Receiving FM stereo.
SLEEP: Sleep timer has been set.
ASb: When Auto Standby function is enabled.
6. Flashes when muting is on.
7. Displays various information of the input signals. Characters that cannot be displayed on
this unit are replaced with asterisks ( ＊ ).
Supplementary information | Firmware Update | Others
 
E
N