Remote Control - Dyson pure hot+cool HP01 Instrucciones De Seguridad

Power
Each time the heating mode is selected, it conducts
a short calibration cycle. Airflow will be automatically
controlled during this cycle. Once the calibration cycle
is complete, it will revert to the selected airflow speed.
On first use, the machine will default to a temperature
5°F higher than the detected room temperature.
Thereafter, the machine will remember the last target
temperature set.
Select the desired room temperature. Pressing the
large red button on the remote control increases the
target temperature by 2°F; the smaller red button on
the remote control decreases it by 2°F. The machine
will not operate in heater mode unless the target
temperature is above the room temperature.

Remote control

Standby
ON/OFF
Airflow speed
control
Sleep timer
Focused
mode
Remote control docks magnetically.
Attach the remote control to the top of the
machine with the buttons facing down.
8
Cooling
mode
Thermostat
control
Oscillation
ON/OFF
Diffused mode
To operate, point the
remote control toward
the front of the base.
Press and hold the power button to run through the
target temperatures.
Heating and cooling modes
Press the red thermostat control button until the digital display
shows the target room temperature. The power button light will change
from blue to red to indicate that you have entered heating mode. The
heating symbol will be red while heating and will change to white when
the target room temperature has been reached. Once the target room
temperature has been reached, the machine will stop heating the air.
If the room temperature falls below the target temperature, the machine
will start to heat again. The red circle surrounding the power button
remains on when the machine is in heater mode. To adjust the airflow
speed use the airflow control button.
Press the blue cooling mode button to enter cooling mode.
The power button light will change from red to blue to indicate that
you have entered cooling mode. To adjust the airflow speed use the
airflow control button.