Remote Control - Dyson Pure Hot+Cool HP01 Guia Del Usuario

Power
Each time heating mode is selected, it conducts a
short calibration cycle. Airflow will be automatically
controlled during this cycle. Once the calibration cycle
is complete, it will revert to the selected airflow speed.
On first use, the machine will default to a temperature
3°C higher than the detected room temperature.
Thereafter, the machine will remember the last target
temperature set.
Select the desired room temperature using the
Thermostat control button. Press the large red
button on the remote control to increase the target
temperature by 1°C; press the small red button
on the remote control to decrease it by 1°C. The
machine will not operate in heating mode unless the
target temperature is above the room temperature.

Remote control

Standby
ON/OFF
Airflow speed
control
Sleep timer
Focused
mode
Remote control docks magnetically
Attach the remote control to the top of the machine
with the buttons facing down.
6
Airflow speed control
Cooling
mode
Thermostat
control
Oscillation
ON/OFF
Diffused mode
To operate, point the
remote control toward the
front of the base.
Press and hold the Power button to run through the
target temperatures.
Press the red Thermostat control button until the digital display shows
the target room temperature. The power button light will change from
blue to red to indicate that you have entered heating mode. The heating
symbol will be red while heating and will change to white when the target
room temperature has been reached. Once the target room temperature
has been reached, the machine will stop heating the air. If the room
temperature falls below the target temperature, the machine will start to
heat again. The red circle surrounding the power button remains on when
the machine is in heating mode. To adjust the airflow speed, use the airflow
control button.
Press the blue Cooling mode button to enter cooling mode. The power
button light will change from red to blue to indicate that you have
entered cooling mode. To adjust the airflow speed, use the airflow
control button.