Stopping The Cleaner And Removing From The Pool; Rinsing The Cleaner; Cleaning The Filter Canister - Polaris 8050 Sport El Manual Del Propietario

Page 10
• Press to adjust the wall climbing setting
one level higher.
• One additional LED lights each time you press
the button to indicate stronger grip on the wall.
• To decrease setting, press button to cycle
through back to one LED (lowest setting).
_
1
2
3
+
4
4.5 Stopping the Cleaner
and Removing from the Pool
1. If the cleaner is still in operation, press
to interrupt operation. If cleaning cycle is
complete, begin at Step 2.
2. When the cleaner is within arm's reach, pull
gently on the floating cable to bring the cleaner
handle within arm's reach.
3. Use the handle to lift the cleaner from the water
and hold the cleaner vertically over the pool
surface to drain (see Figure 14).
Never lift the cleaner out of the pool by the
floating cable.
1
Figure 14. Lift Cleaner From Pool with Handle,
then drain Out the Water
4.6

Cleaning the Filter Canister

Always empty and clean the filter canister at the end of
each cleaning cycle.
WARNING
To avoid electric shock and other hazards which
could result in serious injury or death, disconnect
(unplug) the cleaner from the power source before
performing any cleaning and maintenance.
1. Unplug power to the cleaner at the control unit.
Unplug the control unit from the power source.
2. Press the PUSH 'N' GO
the filter canister handle (see Figure 15).
3. Grasp the filter canister handle and lift up to
remove the filter canister (see Figure 16).
2
3
button (1) to release
®