Irc-6 (Infrared Remote Control 6) Operation - Chauvet GigBAR IRC Manual De Instrucciones

IRC-6 (Infrared Remote Control 6) Operation

Note: Make sure to point the IRC-6 directly at the receiver on the product.
Note: The IRC-6 will not respond to any inputs when Black Out is activated. If the remote does not respond when a button is
pressed, try pressing <BLACK OUT>. You may have inadvertently activated Black Out.
Page 30 of 158
Automatic Mode
Automatic mode will enable you to run the automatic programs on the product.
To turn on Automatic mode:
·
Press and hold <AUTO> on the IRC-6.
·
Press any number between <0> and <9> to choose your auto program.
<0> All On
o
<1> AP01
o
<2> AP02
o
<3> AK01
o
<4> AL01
o
·
Press <+> or <–> to either increase or decrease the speed of the program.
Sound-Active Mode
Sound-Active mode will enable the product to respond to the music.
To turn on Sound-Active mode:
·
Press and hold <SOUND> on the IRC-6.
·
Press any number between <0> and <9> to choose your auto program.
<0> All On
o
<1> SP01
o
<2> SP02
o
<3> SK01
o
<4> SL01
o
Strobe Modes
To adjust the strobe program and rate:
·
Press and hold <STROBE> on the IRC-6.
·
Press <0> to Strobe All, or any number between <1> and <9> to choose your auto
program.
·
Press <+> or <–> to increase or decrease the strobe rate.
·
Press <STROBE> again to turn off the strobe.
Miscellaneous Operation
To adjust the fade rate of the Par and Derby color output:
·
Press and hold <FADE> on the IRC-6.
·
Press <+> or <–> to increase or decrease the fade rate.
To adjust the brightness of color or strobe:
·
Press <%> on the IRC-6.
1 x Press
100%
To black out the lights:
·
Press <BLACK OUT> on the IRC-6. This will turn off all the lights until the button is pressed
again.
2 x Press 3 x Press
75% 50%
<5> APK1
o
<6> APL1
o
<7> AKL1
o
<8> APKL
o
<9> AKLS
o
<5> SPK1
o
<6> SPL1
o
<7> SKL1
o
<8> SPKL
o
<9> SKLS
o
4 x Press 5 x Press
25% 0%
GigBAR™ IRC User Manual Rev. 8