Cleaning The Load Cell; Subsequent Treatment; Removing The Load Plate At Pbk98_-Cc; Disposal - Mettler Toledo PBK9 Serie Manual De Instrucciones

1
3
10

Disposal

4.2 Cleaning the load cell

The load plate has to be removed in order to clean the load cell.
NOTICE
Damage to the load cell due to improper handling.
▲ Never touch, direct compressed air against or spray the rubber membrane (1) of
the load cell.
1. Remove load plate or open weighing platform, see section 4.4.
2. Blow out dirt or flush out with a medium-power water jet (< 2 bar).
3. Replace load plate or close weighing platform see section 4.4.

4.3 Subsequent treatment

In order to protect the weighing platform, carry out the following subsequent treatment:
➜ Rinse the weighing platform with clear water and remove cleaning agent completely.
➜ Dry off the weighing platform with a lint-free cloth.
➜ Treat the inside and outside of the weighing platform with an oil suitable for foodstuffs.

4.4 Removing the load plate at PBK98_-CC

1. Remove the load plate by pivoting the two side handles (1) outward.
1
2
2. Replace the load plate (2) so that the symbol  is located above the level indicator.
3. Make sure that the load supports (3) in the corners of the weighing platform are
vertical.
5 Disposal
In conformance with the European Directive 2002/96 EC on Waste Electrical and Electronic
Equipment (WEEE), this device may not be disposed of with domestic waste. This also
applies to countries outside the EU, according to their specific requirements.
➜ Please dispose of this product in accordance with local regulations at the collecting
point specified for electrical and electronic equipment.
PBK9-series 30233040A