Connecting The Power Pack And Charging The Battery Block - Seca 645 Manual Del Usuario

Connecting the power
pack and charging the
battery block
88 •
WARNING!
Using the wrong power packs may cause bodily
injury or damage to the device
Conventional power packs may deliver a higher
voltage than is indicated on them. The scale
may overheat, catch fire, melt or short-circuit.
– Use only original seca plug-in power packs
with a 9 V or controlled 12 V output voltage.
1. If required, insert the power supply connector nec-
essary for your power supply into the power pack.
2. Insert the connector of the power pack into the
connecting socket of the scale.
3. Plug the power pack into a power supply socket.
4. Leave the scale connected to the power supply for
at least 24 hours when charging for the first time in
order to charge the battery block fully.