Quick Programming - Bentel Security B-TEL2 Manual De Instalación Y Usuario

B-TEL2 is supplied from the factory partially programmed with the following default parameters:
ˆ
Inputs 1, 2 and 3 Inputs set with the command POSITIVE MISSING (See Tab. 2);
ˆ
Inputs 4 programmed for the Stop Alarm function with the command POSITIVE PRESENT (See Tab. 2)
B-TEL2 is activated when Input 1 receives an alarm signal: in this case, the first 3 telephone numbers in the
phonebook (if programmed) are called, and voice message 1 will be sent to each of the numbers.
The device will also be activated (default setting) when Input 2 receives an alarm signal: in this case too, the
first 3 telephone numbers in the phonebook (if programmed) are called, and voice message 2 will be sent to
each of the numbers.
To program the device:
1.) Access the Installer Menu as follows:
where <Installer Code> is a number consisting of 4, 5 or 6 digits (the default installer code is 0001).
2.) Program the telephone numbers to be called:
 
?    @
 
?    @
 
?    @
3.) Record the voice messages:
 
?    @
?   @  

4.) Exit Programming Mode:
D
Press key
As soon as the above procedures have been carried out, B-TEL2 will be ready for operation.
For further information relating to the programming of telephone numbers and the recording of messages,
please refer to the paragraphs entitled "Programming Telephone Numbers" and "Record Voice Messages" in
the next chapter, "PROGRAMMING".
36

QUICK PROGRAMMING

QUICK PROGRAMMING QUICK PROGRAMMING
QUICK PROGRAMMING QUICK PROGRAMMING
A
<1st Telephone Number in the Phonebook>
<2nd Telephone Number in the Phonebook>
<3rd Telephone Number in the Phonebook>
C
<pause> <Start recording the 1st message (Input 1)>
C
<pause> <Start recording the 2nd message (Input 2)>
C
<Installer Code>
C
(Must ALWAYS be programmed)
C
(If required)
C
(If required)
B-TEL2