Main Window - Bentel Security B-TEL2 Manual De Instalación Y Usuario

This chapter describes how to program the dialer with a PC. A PC can be used to set all the parameters necessary
for dialer operation, as well as modify the dialer's operations to suit the user's specific needs and installation.
This chapter also describes in detail all the parameters that can be programmed by the installer and the user.
A particular cable (GSM/LINK) is also needed to program the dialer by PC. The cable diagram is shown in Figure
2. This cable is connected between the PC's RS232 serial port and the connector [10], present on the dialer's
board.
Once the PC is connected to the dialer, the software application can be launched and the programming performed,
as described in this chapter.
Once the application is launched, a window similar to the one shown in Figure 4 will appear. This paragraph
describes all of the window's components.
Menu Bar - This bar contains all the different menu items used not just to program client data, but also to
manage several important PC settings.
Bookmark Bar - The settings of multiple clients can be kept open at the same time (see menu File -> Open...).
One can use the bookmark bar to instantaneously recall the settings of an open client: simply click on the
corresponding "bookmark". Once the "bookmark" is selected, the right mouse key can be clicked to save data
or close the client profile. Be sure to save all client data or changes before closing.
Client Info Button - Click on the
is a meter that advances automatically. This parameter does not keep track of deleted clients: therefore one will
be assigned the first free number by clicking on the
Send/Load All Button - With a single click, these buttons can load all parameters programmed into the dialer
to the PC memory (Board Load, green arrow button,
(Send to Board, red arrow button,
Choose Programming Page Window - Various programming pages can be selected from this window. When
a page is selected, a series of data to program will appear in the Parameters Area.
Page names may not always be visible. Click on the Client Bar to view page names.
Parameters Area - This part of the window shows all parameters that can be programmed. Parameters are
grouped according to the page selected and are sorted into sections to facilitate data input. See the
PROGRAMMING paragraph for a detailed description of these parameters.
0HQX %DU
%RRNPDUN %DU
&OLHQW %DU
,QIRUPDWLRQ DQG
6HQG/RDG $OO EXWWRQV
&KRRVH 3URJUDPPLQJ
3DJH :LQGRZ
3DUDPHWHUV DUHD
Fig. 4 - Main window
4 Channel telephone dialler
PROGRAMMING BY PC

MAIN WINDOW

MAIN WINDOW MAIN WINDOW
MAIN WINDOW MAIN WINDOW
button to set client data (name, phone, address, etc.). The Account Code
).
button.
) or send all client programming to the dialer's memory
G
45