Bentel Security B-TEL2 Manual De Instalación Y Usuario página 44

Voice Message Settings
Before recording messages, set message duration and number of messages by entering the following formula:
where <Message Number/Duration> is a number between 0 and 4:
= two messages, each 32 seconds long (factory setting);
= four messages, each 16 seconds long;

= one 32 second long message and four messages, each 8 seconds long;

= eight messages, each 8 seconds long.
Record Voice Messages
Follow this procedure to record voice messages:
?
1. Press the key;
2. Key in the number
@
3. Press the key.
At this time, any message previously recorded will be ERASED.
4. Wait until the display shows the dash
5. Move near the microphone [2] shown in Fig. 1 and press the
show the number of seconds left until the end of the message;
If you wish to interrupt message recording, press the
6. Record additional messages, as necessary, by repeating the procedure from Step 1.
Playback Voice Messages
Follow this procedure to playback voice messages:
?
1. Press the key;
2. Key in the number
B
3. Press the key.
Repeat Voice Messages
To program the number of repetitions for all voice messages, enter the following formula:
where <Number of repetitions> is a number between 1 and 9 (factory set at 1: a voice message will be sent only once).
44
?    @ 


followed by the number of messages that will be recorded (from
-

followed by the number of the voice message to be playbacked (from
?   @  

<Message Number/Duration>
;
D
<Number of repetitions>
C
C
key to begin recording. The display will
key.
C
 
to );
 
to );
B-TEL2