Bentel Security B-TEL2 Manual De Instalación Y Usuario página 35

Display programmed values
View the value of a previously programmed section in the following manner:
where <Section Number> is a 3-digit number.
If, for example, one wishes to view the third telephone number programmed (section 103, see Table 3a), the
following procedure will be used:
?
to select the section;

to select the third telephone number;
B
to view the requested value, which will be shown on the display in sequence, figure by figure, at regular
intervals. After a value is viewed, or if the section does not contain any programmed data, the dialer returns
to the standby state.
Firmware revision
Find out which revision of B-TEL2 firmware the board is using by entering the programming phase and keying
in the following formula:
The display will show, in order, the firmware revision numbers (
Exit programming mode
To exit programming mode at any moment, press the key
D
If, for example, is pressed while a value is being programmed, or after
the standby state. However, if
mode.
4 Channel telephone dialler
?
<Section Number>
 
?    B
D
is pressed when the display shows the letter
B
r 1 0 0
).
D
once or twice.
C
is pressed, the dialer returns to
P
, the dialer will exit programming
G
35