Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
2. PREPARE THE INSTALLATION
When performing installation, servicing or cleaning the unit, it is recommended to wear safety glasses and gloves.
NOTE: Before proceeding to the installation, check the contents of the box. If items are missing or damaged, contact the manufacturer.
Make sure that the following items are included:
- Range hood
- Accessories:
• Baffle filters
• Baffle filters handles (located inside the hood)
• 3¼" x 10" adapter/damper (located inside internal single blower hood)
• 4½" x 18½" adapter (screwed inside internal double blower hood)
• In-line and exterior blower rough-in plate model 332KR (mounted inside all external blower hoods)
• Bag of parts including:
1 wire clamp, 9 no. 8 x 1/2", 2 wire connectors, 8 no. 8-32 x 1/4" screws, 4 no. 8 x 3/8" screws
Parts sold separately:
- In-line blower assembly HLB3, HLB6, HLB9 or HLB11 (all include transition)
- Exterior blower assembly 331H, 332H, 335 or 336
- Shielded halogen bulbs (120 V, 50 W max., GU-10) (2 required for 30" and 36" hood widths, 3 required for 42" and 48" hood widths)
- RMP Series Backsplash (optional)
- ANKE60 Series Recirculation kit, mandatory for non-ducted installation (models with built-in blower(s) only)
- Transitions, duct, elbows, dampers, wall or roof cap
Refer to pages 3 and 4 for a complete list of venting options and model numbers.
NOTES: 1.
For cabinets with recessed bottom, attach three wood filler strips cut to length (not included), on each side, as shown below.
See illustration and table below for wood filler strips location.
2.
For hoods with external or in-line blowers, do not install the transverse wood filler strip.
H
OOD
C
ENTER OF WOOD
W
IDTHS
(A)
STRIP LOCATION
30"
13 3/8"
36"
16 3/8"
42"
19 3/8"
48"
22 3/8"
WARNING
!
A
HD0285A
6
L C
A
10"
Publicidad
Tabla de contenido
