S&P CK-25 Manual De Instrucciones página 9

Installation at the top of the hood
The extractor is secured inside the
top of the hood by means of 4 screws
(fig.4).
Electrical wiring
Function of the model; follow the wiring
diagram indicated fig.8.
Use and maintenance
We recommend that the extractor is left
running for about 15 minutes after coo-
king has finished in order to completely
exhaust all of the stale air.
The correct operation of the extractor
depends on regular maintenance, es-
pecially for those models fitted with a
grease filter (CK-40F & CK-60F).
ATTENTION: Before cleaning the ex-
tractor make sure that the fan blade
has completely stopped.
Clean regularly to remove all the grea-
se deposits, on the inside and outside
of the extractor. All the components
should be cleaned at least every two
months.
Cleaning is simple and can be carried
out without the need for any tools. To
proceed, first remove the grease tray by
sliding it out on its runners (fig.5). Then
withdraw the outside cover by pressing
on the side buttons. Once the cover is
off, unscrew the fan blade (fig.6).
To clean the scroll, simply wipe it with a
damp cloth soaked in household non-
abrasive detergent.
The CK-40F and CK-60F units, are fit-
ted with filters which are designed to
retain the grease particles this of cour-
se means that they will become dirty
through use of the extractor.
At least every two months, clean the
filter following the instructions set out
below:
- First remove the external cover, then
release the filter from the cover by
loosening the plastic nuts which are on
the inside (fig.7).
- Wash the filter with water and a mild
detergent.
- Rinse thoroughly and leave to dry be-
fore fitting back into the cover.
- The filter can also be washed in a dis-
hwasher.
- Failure to follow this maintenance pro-
cedure could cause a fire risk should a
flame come near or into contact with
the filter.
ATTENTION: In some circumstances
household electrical appliances can
be dangerous
- Do not remove the external cover whi-
le the extractor is running
- Do not "flame" any food beneath the
extractor
- Avoid using the hotplates without a
saucepan in place covering the ring or
flame as this can damage the extractor
and cause a fire
- Take particular care when frying food
to ensure that the hot oil does not catch
fire
- Before carrying out any maintenance
operation, make sure that the mains
supply is switched off.
S&P does not hold itself responsible for
any instance arising from the incorrect
use or mis-installation of the extractor
or if the maintenance instructions have
not been carried out correctly.