Install The Batteries - JVC LT-19HA22U Manual De Instrucciones

Remote Control

Install the batteries

Use batteries type UM3 (AA-Size).
Do not use old or weak batteries. The remote control may not work properly with a weak voltage from such
batteries. Replace exhausted batteries with new ones. Never try to recharge normal batteries - this could
cause an explosion.
Note:
• Exhausted batteries can leak corrosive electrolyte, which may cause damage to the remote
control - therefore remove exhausted batteries immediately.
• Batteries should not be exposed to excessive heat such as sunshine, fire or the like.
1
Open the battery
compartment.
Distance of Remote Control Operation
The remote control handset will not work properly in the following cases:
a) If bright sunlight directly beams onto the unit front. b) If an obstacle is placed between the unit and the
c) If the batteries have not been installed
according to their polarities.
2
Install the batteries as shown
below, ensuring the correct
polarity.
Remote sensor
Maximum distance approx. 5m
Transmitter window
3
Point the remote control
30 30 directly at the remote sensor.
handset.
d) If the batteries are weak.
Close the battery
compartment.
9