Faber CAMINO PRO Serie Instrucciones De Instalación página 22

open space
upper
cabinet
rangehood
cooking surface
For recirculating installations, Charcoal Filters are necessary. Remove all grease filters
and set aside. Attach one charcoal filter to each end of the blower. Each charcoal filter
attaches to the grid on the side of the blower. Rotate the filter clockwise to install and
counterclockwise to remove (FIGURE 3C). Replace all grease filters.
Some duct work must be installed to exhaust the rangehood back into the kitchen, either
at the top of the cabinet (FIGURE 3A) or at the face or side of the soffit (FIGURE 3B).
Install at least 15" of metal duct (fig.3A and 3B) at the air exit. Run the duct vertically and
secure it at the opening cut out at the top or side of the cabinet or soffit. Installation
Required Activated Charcoal Filter Accessory - sku
# - FILTER1
Long Lasting Activated Charcoal Filter Accessory -
sku # FILTER1LL
(purchased separately)
22
RECIRCULATION INSTRUCTIONS
enclosed soffit
upper
cabinet
rangehood
cooking surface
RECIRCULATING INSTALLATIONS
This page needs to be inserted
This page needs to be inserted
after Page 9 and before Page 10
after Page 9 and before Page 10
Note: recommended for 600 CFM
version only
Note: It is recommended that pro­
fessional style cooking always be
vented to the outside; for recirculat­
ing installations, some duct work is
required to exhaust the unit out of
the cabinet.
Add the new
Add the new
kit
kit
:DUCTGRT42
:DUCTGRT42
–(42")
–(42")