Faber CAMINO PRO Serie Instrucciones De Instalación página 68

INSTALACIÓN DE LA CAMPANA DE 2 MOTOR SUPERIOR DE CONDUCTO
1
Coloque los 2 motores en el cuerpo de la campana. Dentro de la campana hay un divisor de
soporte del ventilador y los motores estarán uno por lado.
2
Instale los 2 motores a los lados del soporte del ventilador utilizando los 4 tornillos 12e
suministrados.
3
Extremo de
9 agujeros
68
B
FIGURE 15
3. Attach the blower bracket divider inside the hood, with the 2
screws into the top of the hood and 2 screws into the back, all
supplied with the blower kit (FIGURE 16)
FIGURE 16
4. Install the 2 motor kits into the sides of the blower bracket using
the 4 screws supplied with the motor kit. (FIGURE 17)
5. Connect the wire (FIGURE 18) that comes with the motor kit
from the side of the two motors to the connection on the inside
of the light panel in the hood. The two - 9 hole ends of the wire
are installed in the two motors, the 6 hole end is connected to
the light panel (FIGURE 11 on the previous page)
FIGURE 17
Extremo de
9 agujeros
FIGURE 18
6. Install the 2 dampers on top of the hood. If you want one 10"
round duct to come out of the top of the hood, use the transition
piece (FIGURE 19) that comes with the motor kit and install with
four screws. If you want to use 2 seperate 6" round ducts, do not
Conecte el extremo de 9 agujeros del
use the transition.
cable al motor izquierdo y el otro extremo
7. Attach the hood to the cabinet using (12) 9c. screws to the
de 9 agujeros del cable al motor derecho.
cabinet. FIGURE 20
8. Follow steps 6 - 9 on the previous page to connect ducting,
wiring, and test the electrical connection.
wiring, and test
Extremo de
9 agujeros
FIGURE 19
FIGURE 20