Indirect Measurements - Hilti PD-I Manual De Instrucciones

5.13 Pythagoras
5.13.1 Single Pythagoras
1. Aim the tool at the target point and press the "Measure" button.
2. Aim the tool at the next target point and press the "Measure" button.
Note
In order to achieve accurate results, the second distance must be measured at right angles to the
target distance.
5.13.2 Double Pythagoras
1. Aim the tool at the target point and press the "Measure" button.
2. Aim the tool at the next target point and press the "Measure" button.
Note
In order to achieve accurate results, the second distance must be measured at right angles to the
target distance.
3. Aim the tool at the third target point and press the "Measure" button.
5.13.3 Combined Pythagoras
1. Aim the tool at the target point and press the "Measure" button.
2. Aim the tool at the next target point and press the "Measure" button.
3. Aim the tool at the next target point and press the "Measure" button.
5.14 Settings
5.14.1 Editing the favorites list
1. Navigate to the function that you wish to edit and confirm by pressing the "Measure" button.
2. Navigate to the desired function and confirm by pressing the "Measure" button.
5.14.2 Activating the scale
1. Set the applicable number and confirm the value by pressing the "Measure" button.
2. Select the check mark symbol (tick) to confirm the value.
5.14.3 Calibrate inclination sensor
1. Place the tool on a horizontal surface and press the "Measure" button.
2. Rotate the tool through 180° and press the "Measure" button.
◁ The inclination sensor is now calibrated.

5.15 Indirect measurements

5.15.1 Indirect horizontal distance measurement
▶ Aim the tool at the target point and press the "Measure" button.
◁ The distance and angle of inclination are measured and shown in the intermediate result line.
◁ The target distance is calculated immediately and shown in the result line.
5.15.2 Indirect vertical distance (2 angles, 2 distances)
1. Aim the tool at the target point and press the "Measure" button.
◁ The first distance and angle are measured and shown in the intermediate result line.
◁ The graphical display automatically prompts you to measure the second distance.
2. Aim the tool at the next target point and press the "Measure" button.
◁ The target distance is calculated immediately and shown in the result line.
5.15.3 Measuring on ceilings
1. Aim the tool at the target point and press the "Measure" button.
◁ The first distance and angle are measured and shown in the intermediate result line.
◁ The graphical display automatically prompts you to measure the second distance.
9