Front Panel; Back Panel; Input Connection; Power Cord Connection - gala gar Smart Tig 310 PACDC Manual Técnico De Instrucciones

5.1 Front panel

5.2 Back panel

5.3 Input connection

5.3.1 Power cord connection

The power supply of this machine is 380V 3-phase (50/60Hz), and an input power cord (4*2.5mm
provided with this machine. Users should connect it to the switching box, and the switching box should meet the
power requirement of the machine. Please refer to the figure on the next page for the connection.
Smart Tig 310 P ACDC
9
Cut off the power supply before any electric connection operation.
1. Front panel film
(Welding mode and parameter selecting)
2. Adjustment knob
(Welding mode and parameter adjusting)
3. Welding conector torch
4. Output terminal of shield gas
5. Socket for torch trigger input
6. Socket for foot control (-)
7. Welding connector (+)
8. Quick socket for water cooling (output)
9. Power switch (wáter cooler)
6. 3-phase input cable junction box (4-wire)
7. Quick socket for water cooling (input)
8. Input terminal of shield gas
9. Ground terminal
10. Fan guard
Pág. 39
) about 3m is
2