Fuses - Tronic KH 3106 Instrucciones Para El Manejo Y La Seguridad

RZ_KH3106_Energiestation.qxd4

8. Fuses

If none of the LED is illuminated after
switching on, one of the two fuses
might have blown- either
- the flat fuse at the back or
- the round fuse at the front.
If an LED is illuminated after switching
on but no current is flowing via the cig-
arette lighter cable regardless, ...
- the cable fuse in the cigarette
lighter connector might have blown.
First set the main switch to "OFF"
and pull all cables from the energy
station before changing any fuses.
In this way you will prevent that the
new fuse will burn in your fingers
if the fault persists – risk of injury!
07.11.2003
Danger!
9:27 Uhr Seite 53
Danger!
Fuses are important protective
devices to prevent damage. Never
render them ineffective but ...
• always replace fuses with fuses
of the same rating, never "high-
er" ratings.
• never bypass fuses, this could
result in fires.
a) Changing round fuse:
• Unscrew the cap at the front of the
round fuse and fit a new "2 A (T2A
250V)" fuse.
b) Changing flat fuse:
Pull out the flat fuse at the back of
your device (e.g. long-nose pliers)
and insert a new "10 A (C10)" fuse.
c) Changing cable fuse:
Unscrew the cable fuse cap on the
motor vehicle connector and
insert a new "1 A (T1A 250 V)"
fuse.
If the fuse is blown again immediately
with the device connected, your device
is loading the energy station with
excessive power consumption – or it is
defective.
53