Electrical Connections - GE GETP35-2 Guia De Instalacion

7
If necessary, join two strips together using a jump
connector or a soldered wire connection. Follow
steps 4b-6b for each end of the jump connection,
or 4a-6a for each end of the soldered wire
connection.

Electrical Connections

NOTE: Do not use connectors pre-filled with silicone
grease/mineral base protective grease or use silicone
grease to seal connections.
Add up total length of system
1
Add up total footage of the system to determine
the appropriate number of 12VDC Class 2 Tetra
power supplies to use based on the Power Supply
Loading chart on last page.
Jumper
connector
®
Mounting surface
8
Remove tape backing and stick Tetra
in place. Ensure the tape is firmly attached.
NOTE: Securing with electrical grade silicone is also
acceptable.
To avoid water ingress or shorting to the mating
surface, all product should be inspected for breaks
in the adhesive backing or silicone cover prior to
installation and any damaged product should be
not be installed.
Do not remove, reposition, or lift the tape once
the adhesive backing has made contact with the
mounting surface.
Power supply
Power supply
2
If installing multiple power supplies, keep them
at least 2" (50.8mm) apart end to end and 4"
(101.6mm) apart along the sides.
4
flexible tape
®
Power supply
4"
Power supply
2"