Tabla de contenido
Publicidad
Tetra
Contour
®
Connect Power Supply
To Tetra Contour
Black or blue (–)
Power
supply
16
Run a wire from the power supply
to a section of Tetra Contour.
Power supply connection must be
completed in an acceptable UL/
NEMA enclosure. Power supply
loading is described in the power
supply installation instructions.
19
Insert wire connectors into
weather box. Fill with electrical
grade silicone and close box.
METHOD B - Installing Light Engines Without Light Guides (Dry Indoor Only)
RISK OF FIRE: Light engine by itself is intended for use in dry indoor application only.
Planning First
Plan the layout by measuring the design layout and dividing by 8 ft . (2.44m) to determine the required quantity of Tetra
Contour. Refer to the Cutting Resolution Table on page 2 when cutting any Tetra Contour section.
Do not use more than one suffix code for each respective application, as mixing suffix codes may result in appearance
variation. Suffix code can be found on the packaging label.
Installation methods shown are for straight runs. For custom shapes, install mounting clips at regular intervals throughout the shape
to provide adequate support for the light engine.
DO NOT bend the light engine to an inside radius that is tighter than 3/4 in. (19mm). The light engine is not intended for excessive
or repetitive bending or stretching. If the silicone does crack, electrical grade silicone can be applied to seal the crack.
If you have questions about these instructions or your Contour application, contact support at tetra.support@gecurrent.com
Red (+)
–
+
17
Separate wires and identify outer
conductors as positive (+) and
middle conductor as negative (-).
Strip ends back 0.5 in. (13mm).
WARNING
RISK OF ELECTRICAL SHOCK:
Turn power OFF before
inspection, installation or removal.
.
Weather box can be painted
Secure the weather box using a
20
#6 or #8 (M2 or M3) screw.
WARNING
Middle wire (–)
+
Black or blue (–)
18
5
Installation Guide
Outer wires (+)
Red (+)
To power supply
Connect the two outer wires (+)
from the LED strip to the red wire
(+) of the power supply. Connect
the middle wire (-) from the LED
strip to the black or blue wire (-)
of the power supply.Grounding
and bonding must be done in
accordance with National Electrical
Code (Article 600). See power
supply instructions.
Publicidad
Tabla de contenido
