Publicidad
Tetra
Atom
®
Electrical Connections
ATTENTION: Do not use connectors pre-filled with silicone grease/mineral base protective grease or use silicone grease to seal connections.
Red stripe (+)
1
NOTE: Connect LED strips using appropriate
connectors and seal with electrical grade RTV
silicone where required.
Red (+)
NOTE: Must be used with Tetra ® 24 Volt Power
3
Supplies.
NOTE: Refer to Maximum Loading & Remote
Mounting Specifications on page 4.
OPTIONAL
A Weather Box (GEXNWB2) may be used
to house and seal Class 2 connections as
described below:
A) Insert wire connectors into weather box. Fill
with electrical grade silicone and close box.
B) Secure the weather box using a #6 or #8
(M2 or M3) screw.
White (-)
Black or blue (-)
LED Controlgear
A
3
2a
2
NOTE: Must cap all exposed wires with appropriate
wire connectors and seal with electrical grade RTV
silicone.
Optional: Cut wires flush to the module and seal with
electrical grade RTV silicone as shown in step 2b.
Red Stripe (+)
4
NOTE: All electrical connections should be suitably
protected from mechanical damage and the
environment. Seal all connections in wet locations
with electrical grade RTV silicone.
B
Installation Guide
2b
Black or
blue (-)
Red (+)
White (-)
Publicidad
