Worx VERSACUT WX420L Manual De Instrucciones página 7

a cut for any reason, switch off the power
tool and hold the power tool motionless
until the wheel comes to a complete
stop. Never attempt to remove the wheel
from the cut while the wheel is in motion
otherwise kickback may occur. Investigate
and take corrective action to eliminate the cause
of wheel binding.
h) Do not restart the cutting operation in the
workpiece. Let the wheel reach full speed
and carefully re-enter the cut. The wheel
may bind, walk up or kickback if the power tool is
restarted in the workpiece.
i) Support panels or any oversized workpiece
to minimize the risk of wheel pinching and
kickback. Large workpieces tend to sag under
their own weight. Supports must be placed under
the workpiece near the line of cut and near the
edge of the workpiece on both sides of the wheel.
j) Use extra caution when making a "pocket
cut" into existing walls or other blind areas.
The protruding wheel may cut gas or water
pipes, electrical wiring or objects that can cause
kickback.
Additional safety rules:
1. Always wear a dust mask.
SAFETY WARNING FOR
YOUR LASER
Warning for class II laser
CAUTION--Laser radiation when open. DO NOT
STARE INTO BEAM
CAUTION--Laser radiation when open and interlock
defeated. DO NOT STARE INTO BEAM
LASER RADIATION--DO NOT STARE INTO BEAM
ADDITIONAL SAFETY
WARNING
Do not stare directly at the laser beam. A hazard may
exist if you deliberately stare into the beam, please
observe all safety rules as follows:
1. The laser shall be used and maintained in
accordance with the manufacturer's instructions.
2. Never aim the beam at any person or an object
other than the work piece.
3. Always ensure the laser beam is aimed at a
sturdy work piece without reflective surfaces, e.g.
wood or rough-coated surfaces are acceptable.
Bright shiny reflective sheet steel or similar is not
suitable for laser applications as the reflective
surface may direct the laser beam back at the
operator.
4. Do not change the laser device with a different
type. The manufacturer or an authorized agent
must carry out repairs.
5. CAUTION: Use of controls or adjustments
other than those specified herein may result in
hazardous radiation exposure.
Mini Circular Saw
6. CAUTION--The use of optical instruments with
this product will increase eye hazard.
SAVE THESE INSTRUCTIONS
7
EN