Festo DGE Serie Instrucciones De Utilizacion página 48

DGE−...−ZR/−SP
· Make sure that the device is installed free
of mechanical stress and distortion
(evenness of mounting surface:
0.2 mm / 30 cm).
Note
Tensile loads on the cover screws that are too high cause them to be pulled out.
· In case of heavy loads, ensure that the axis is not fastened by the front cover
alone.
Articles with long stroke lengths:
· Use the central support MUP−...
Fig. 13 shows the distances between supports necessary for the MUP.
When attaching central supports:
· Position the central supports at equal
distances over the complete axis length,
not only over the stroke path.
· Fasten the centre supports with slot nut
on the DGE as shown in Fig. 11.
When the slot nuts are tilted, they glide
into any position of the profile in the
groove.
· Tighten the mounting screws evenly.
· Make sure that the central supports are
situated outside the positioning range of
the slide by pushing the slide once over
the complete positioning path.
48
Fig. 10
DGE−40...63
Fig. 11
Fig. 12
Festo DGE−...−ZR/−SP 0909f English
DGE−8...25