Laundry Center Care; Cleaning The Dryer Interior - Kenmore 110.88752 Manual De Uso

Air Dry
Use the Air Dry cycle for items that require drying without heat
such as rubber, plastic, and heat-sensitive fabrics. This chart
shows examples of items that can be dried using an air cycle.
Type of Load Minutes*
Foam rubber -- pillows, padded bras, stuffed 20 - 30
toys
Plastic -- Shower curtains, tablecloths 20 - 30
Rubber-backed rugs 40 - 50
Olefin, polypropylene, sheer nylon 10 - 20
*Reset time as needed to allow items to completely dry.
When using Air Dry
• Check that coverings are securely stitched.
• Shake and fluff pillows by hand periodically during the cycle.
• Dry item completely. Foam rubber pillows are slow to dry.
End of Cycle Signal
Your dryer sounds a signal when a drying cycle is finished. This
signal is helpful when you are drying items that need to be
removed as soon as the dryer stops in order to help keep
wrinkles from forming.
LAUNDRY CENTER
CARE
© esss n9 t e Lsus d%J©e LOCat On
Keep Laundry Center area clear and free from items that would
obstruct the flow of combustion and ventilation air.
Explosion Hazard
Keep flammable materials and vapors, such as
gaso(ine, away from dryer.
Failure to do so can result in death, explosion, or fire.
Cleaning the exterior
Use a soft, damp cloth or sponge to wipe up any spills such as
detergent or bleach. Occasionally wipe the outside of your
washer to keep it looking new.
Cleaning the interior
Clean your washer interior by mixing 1 cup (250 mL) of chlorine
bleach and 2 scoops or caps full of detergent. Pour this into your
washer and run it through a complete cycle using hot water.
Repeat this process if necessary.
NOTE: Remove any hard water deposits using only cleaners
labeled as washer safe.
os
Replace inlet hoses after 5 years of use to reduce the risk of hose
failure. Periodically inspect and replace inlet hoses if bulges,
kinks, cuts, wear, or leaks are found.
When replacing your inlet hoses, mark the date of replacement
on the label with a permanent marker.
Every load cleaning
The lint screen is located on the back wall of the dryer. Remove
lint before each load. A screen blocked by lint can increase
drying time.
To clean
1. Pull out the lint screen and its cover.
\
2. Separate the cover and the screen by squeezing the screen
and pulling on the cover at the same time.
A
A. Screen
B. Cover
3.
Roll lint off the screen with your fingers. Do not rinse or wash
screen to remove lint. Wet lint is hard to remove.
4. Put the lint screen and cover back together and push firmly
back into place.
IMPORTANT:
• Do not run the dryer with the lint screen loose, damaged,
blocked, or missing. Doing so can cause overheating and
damage to both the dryer and fabrics.
25