Pintucking; Quilting - KENMORE ELITE 385.19365 Manual De Instrucciones

Pintucking
Q Stitch pattern: 01
(_ Thread tension dial: AUTO
G: Blind hem foot
Place the folded fabric under the presser fool Position the
folded fabric under the presser foot. Position the needle
1/16" (0.,1 to 0,2 cm) inside from the folded edge by turning
the handwheel and lower the presser foot. Adjust the
sliding guide on the blind hem stitch foot to the folded edge
by turning the guide screw°
Feed the folded edge smoothly against the sliding guide.
After sewing is finished, use an iron to make pleats.
Quilting
@ Stitch pattern: 01
_) Thread tension dial: AUTO
G A: Zigzag foot
@ H: Straight stitch foot
(_ Quilter
Note:
When using the straight stitch foot, make sure to use
center needle position., Otherwise the needle may
strike the sewing foot and possibly break,
[] The quilter will keep the stitching lines straight. Loosen
the quilter screw. Slide the quilter in the opening to the
desired width and tighten the screw°
[] Sew guiding the quilter over the previous row of
stitches.
@ Quilter holding screw
(_) Quilter
® Hole
@ Distance
86
f
@ @ ® ®
,,@%%
lax =J do
L___9,UTO A _7_ 3.52.2
J
®