Rotary AR14 Manual De Instrucciones página 16

I. Always recheck the level of the runways to be sure all four
locking latch plates are adjusted correctly. Start at point "A"
and recheck level at points "B", "C" and "D", Fig. 31. Read-
just, if needed.
The runways are now level at all four points.
J. To complete the leveling procedures, lock each locking latch
plate jam nut tightly against bottom of column top plate, Fig.
31.
Locking Latch Plate
Adjustment Stud
Jam Nut
Locking Latch Plate
B
C
Fig. 31
A
2. Rolling Jack:
A. Adjust rolling jack telescopic ends until roller rests on run-
way track rail. Make sure wheels are on tracks and center
rolling jack between runway on end sections.
B. Place jack on runway track at front and rear with air pump
facing ends of runway, Fig. 32.
C. Recommended operating pressure 100-120 psi.
D. Attach rubber stop see Fig. 32.
3. Internal Air Line: (Kit Available)
This lift is equipped with an internal airline that provides air to
both rolling jacks and extra access point for air driven tools
(Quick Disconnect Coupler), Fig. 33. All internal air lines are
factory assembled.
16
D
Fig. 30