Rotary AR14 Manual De Instrucciones página 17

Runway
Rolling Jack
Stop Locations
APPROACH
4. Rear Recoil Hose Installation:
A. Attach retainer brackets for the rear recoil hose with M8 x 30
Lg. hex cap screw, flat washer, lock washer and nut, Fig. 34.
B. Insert retainer cable through coils of recoil hose, Fig. 34. Run
a 1/4"-20NC hex nut down onto each end of retainer cable.
Insert each end of cable into retainer brackets. Secure each
cable end with another 1/4"-20NC hex nut. Tighten jam nuts,
Fig. 34.
C. Connect one end of provided rear recoil hose to bulkhead
T-fitting at midpoint of runway. Connect other end of recoil
hose to coupling welded on rolling jack, Fig. 35 and 37.
D. Connect elbow end of rolling jack tubing assembly to air
pump and male end to the coupling, Fig. 35 and 37.
43"
Stop Locations
Tee Port
Air Inlet
Rear Rolling
Jack Tubing
Assembly
Male Fitting
Air Pump
Rolling Jack
Recoil Hose
Hose Bracket
Rear Rolling Jack
Swing Air Jack - Optional
Front Rolling Jack
Swing Air Jack - Optional
5. Front Recoil Hose Installation:
A. Insert retainer cable through coils of recoil hose, Fig. 34.
Connect one end of recoil hose to coupling welded on rolling
jack, Fig. 37 and 38.
B. Connect other end of front recoil hose to bulkhead T-fitting in
center of runway.
C. Connect elbow end of rolling jack tubing assembly to air
pump, and male end to the coupling, Fig. 37 and 38.
Note: Cut air line tubing with sharp blade to length as required.
Tubing must be cut square with no burrs. To assemble air line
tubing into fitting, use firm, manual pressure to push tubing into
fitting until it bottoms, (see below). If removal of the air line tubing
from the fitting is ever required, hold Push Sleeve in (against
fitting) and, at the same time, pull out on tubing.
17
Flange Nut
Attach rubber bridge stops to 9.5mm
holes 14" off branch tee port. Insert
Fig. 32 M6-35 bolt up through runway and
stop. Attach M6 nut and 6mm flat
washer to top of stop
Hose
Bracket
Fig. 33
Rubber Stop
Track
Bolt Holding
Rubber Stop
.
Quick
Disconnect Coupler
Front Rolling Jack Tub-
ing Assembly