Rotary AR14 Manual De Instrucciones página 19

. Aligning Turning Radius Guide Bars:
6
A. Slightly loosen the turning radius gauge guide bar mounting
bolts.
B. Place a string (weights on each end) across the runways so
that the string is touching along the full length of both rear
guide bars, Fig. 39. If the string is not touching, tap the ends
of the guide bars lightly until the guide bars make full contact
against the string. Tighten the rear guide bar mounting bolts
securely and remove the string.
C. Place the turning radius gauges in the recesses of
both runways with the pointer and lock pin to the
outside of lift, Fig. 40. Position each gauge against the rear
guide bars. Then position the front guide bar just against
the front edge of the turning radius gauge. Repeat on other
runway. (A tolerance of 1/16", end-to-end, would be accept-
able.) Tighten the mounting bolts securely. The turning radius
gauges are now square and in proper alignment with each
other.
Front Recess
AR14
WHEEL SERVICE
Turning Radius
Gauge
19
Align Bars with
String
Fig. 39
Fig. 40
Wheel
Weights
Runway