Changing Channels; Button - Topcom PMR BABYTALKER 1010 Manual De Usuario

TOPCOM Babytalker 1010
21 Using the Parent unit as a PMR
Besided using the Parent unit as receiver for the Baby unit transmission, you can use it to
communicate with other PMR (Private Mobile Radio) users which are on the same channel.

21.1 Changing Channels

To use the Parent Unit as a standard PMR, the Channel Memory
function must be disactivated (See chapter 15.2) and the unit must
be set to the same channel as your correspondent PMR.
21.2 Receiving a Signal
21.3 Transmitting a Signal
To check the channel activity use the monitor function (See chapter
21.6). Release and press the
12
• Press the

- button

flashes on the display.
• Press the - button
channel.
• Press the PTT - button
mode.
The Parent Unit is continuously in RECEIVE mode when the unit is
switched ON and not transmitting. When a signal is detected the RX
icon will be displayed.
• Press and hold the
symbol is displayed.
• Hold the unit in a vertical position with the MICROPHONE 10cm
from the mouth and speak into the microphone.
• Release the PTT
15
once , the current channel number
19
or the - button
20
to confirm and return to stand-by
20
- button to TRANSMIT. The TX
PTT
20
- button when you want to stop transmitting.
20
- button to restart transmitting.
PTT
18
to change the
TOPCOM Babytalker 1010