Adding A Further Lawn Area (See Figure H) - Bosch Indego XS 300 Manual Original

24 | English
Action
Laying perimeter wire around new in-
ner object
Lifting up and carrying the mower
Setting the height of cut
Adding a further lawn area
– with additional docking station
(right)
– without additional docking station
(top left)
Cleaning
Maintenance
Software update
Installation
With the following QR code, you can view a video on how to
install the mower under www.bosch-diy.com/indego-help.
Alternatively, follow the Installation Guide delivered with the
product.
Check if the perimeter wire is fully pegged to
the ground avoiding any slack lengths of wire.
Any loose wire can be a trip hazard.
Remove stones, loose pieces of wood, wire, live mains
cables and other foreign objects from the cutting area.
Make sure that the cutting area is even and has no ditches,
grooves and steep slopes above 15°/27 % that are clear ob-
structions for the mower.
The docking station must be positioned on the wire at an
outer edge of the cutting area. It may not be positioned on
the side of a tool or garden shed standing as an island within
the lawn to be mowed.
It is recommended that you mow your lawn once with a con-
ventional lawnmower before installing and before the first
mowing of the new season and whenever the grass clippings
would be longer than 5 mm.
The mower's cutting system is designed to cut small lengths
of grass (30–50 mm). The clippings can remain as mulch to
fertilize the lawn. The height of cut for mower can be adjus-
ted to 30, 40 and 50 mm.
It is recommended to start with a higher setting and then
gradually decrease the height of cut as the wire disappears
under the grass. This prevents your Indego from cutting the
wire.
Additional perimeter wire can be added using a wire con-
nector (see figures D–E).
F 016 L94 037 | (11.11.2020)
The perimeter wire can be extended up to a maximum length
Figure Page
of 250 m.
E 304
The perimeter wire can be buried up to 5 cm under the
ground (or under non-metallic slabs).
F 305
To avoid causing damage to the perimeter wire, do not verti-
G 305
cut or rake the area where it is positioned.
H 306
When laying out the wire avoid angles of less than 45°. This
can affect the performance.
Display
I 307
J 307
K 308
Symbol
➊
➋
➌ ○
➍ ○
➎
➏
➐
➑ 1 2 3
The display switches into sleep mode, if no input is made for
10 minutes.
Adding a further Lawn Area (see
figure H)
To install the Indego to an additional lawn area, please follow
the instructions in the Installation Guide.
Meaning
Back button
Confirm button
If the confirm button is pressed whilst mow-
ing, the mower will return to the docking
station
Red LED on: mower error
Green LED on: mower is switched on
Green LED off: The mower is inactive and
your four-digit PIN code is required for ac-
tivation.
Or the mower is shut off, the isolator switch
must be turned on and your four digit PIN
code must be entered to activate the
mower.
Note: during a software update, the green
LED and red LED will be on.
Left/right button
Down/up button
Display with dialog screen
Garden number (shown when more than
one garden map in the mower memory)
Bosch Power Tools