GALAGAR GAR CUT 2500 Manual De Instrucciones página 23

MAINTAIN THE STATE AND EFFICIENCY OF THE AIR DIFFUSER, NOZZLE-HOLDER AND SWIRL-
RING.
The air outlet holes of these components must be free from occlusions. Faulty air diffusion causes the torch
to heat up too much, with the subsequent deterioration of the torch head.
KEEP THE NOZZLE CLEAN OF OCCLUSIONS AND SLAG.
Clean the nozzle from time to time. If there is slag on the surface base there could be arc ignition problems.
Use a cleaning brush, never sharp elements, as the nozzle hole could be deformed.
DO NOT CUT WITH THE TORCH VERY HOT.
BRUSH THE NEW ELECTRODES.
GAR CUT (V. INDUSTRIAL). Instructions Manual
Assembly sequence of torch head P150.
23